A windowsill can read 900 lux at nine in the morning and 150 lux at four in the afternoon without anything moving except the sun. Those are two different growing environments sharing one sill, and the gap explains why a plant that looked content in May starts dropping leaves in December. Numbers help only if you know which number you are holding.
Three different numbers people call ‘light’
Lux and foot-candles measure illuminance, the light our eyes perceive. One foot-candle equals 10.76 lux, so a reading of 1,000 lux is about 93 foot-candles; the conversion is simple, but neither unit says much about photosynthesis. PPFD counts photons in the 400–700 nm band that plants use, in micromoles per square metre per second (µmol/m²/s). DLI multiplies PPFD by the seconds of light in a day and reports the total in moles per square metre per day.
| Measure | Unit | What it describes | Working range |
|---|---|---|---|
| Lux | lx | brightness to human vision | dim room 200–1,000; bright window 2,000–20,000 |
| Foot-candles | fc | the same, in imperial units | 1 fc = 10.76 lx |
| PPFD | µmol/m²/s | usable photons arriving each second | low-light plant 50–150; high light 300–600+ |
| DLI | mol/m²/day | PPFD accumulated over the day | 4–6 low; 10–16 high |
The bands overlap between species and settings, so treat them as working ranges rather than thresholds. A “low-light” plant is not one that tolerates darkness; it is one that photosynthesises usefully at levels where a tomato seedling would stretch and pale.
What a phone light meter can and cannot tell you
Phone light-meter apps read the camera or the ambient sensor and convert the result to lux. They are uncalibrated, they weight green light the way the eye does, and they respond poorly to the sharply angled light from a panel or a window at the edge of the frame. For comparing two corners of the same room with the same phone, they are genuinely useful. For turning the output of a red-and-blue LED into PPFD, they are close to useless.
You can improve the comparison by taping a sheet of white paper over the sensor so it collects light from a wide angle, holding the phone flat at canopy height, and taking three readings at the same spot. Write the numbers down rather than trusting memory. What the phone cannot do is give you a daily total, describe the spectrum, or tell you that a leaf three centimetres lower is receiving half the light of the one above it.
Mapping your windows through the day
Choose a clear day and a cloudy one, and take readings at 8 a.m., noon, and 3 p.m. at the height of the leaves, not on the floor. Then repeat in midwinter. A north window in a northern city may receive no direct sun in December, with midday readings in the low hundreds of lux, while the same glass in June can pass several thousand lux on a bright morning. A south window gains as the winter sun tracks lower and reaches further into the room; an east window delivers a sharp morning peak and little after lunch.
Record the hours of direct sun as well as the readings, because two hours at 50,000 lux contributes far more than eight hours at 800 lux. Watch for what a single measurement hides: the eave that shades the sill from October, the neighbour’s tree that leafs out in May, the balcony rail that cuts the afternoon. A plant placed for June light is often in trouble by November, and moving it 40 cm closer to the glass can matter more than any gadget.
Grow light distance, hours, and heat
For a small source, intensity falls with the square of distance: double the gap from 30 cm to 60 cm and roughly a quarter of the light reaches the canopy. A 60 cm panel is not a point source, but the trend still governs its edges. Start a panel 20–30 cm above seedlings and 30–45 cm above established plants, then adjust by watching the plants rather than the marketing sheet. If the maker publishes a PPFD map, use it to compare positions at the same height, not to predict what your leaves receive.
Twelve to sixteen hours is the usual supplemental photoperiod; a cheap timer removes the daily decision. Longer than about 18 hours gives most plants little extra and leaves fewer hours to recover, and round-the-clock light is a stress test rather than a growth strategy. Heat is the other variable: LEDs put less heat into the room than old-style bulbs, but the leaf surface under a panel still runs warmer than the air, so hold the back of your hand at canopy height for ten seconds. If it feels hot, the light is too close regardless of what the box claims.
| Gap to canopy | Relative intensity |
|---|---|
| 15 cm | 4× |
| 30 cm | 1× (reference) |
| 60 cm | 0.25× |
| 90 cm | 0.11× |
Matching a plant to a spot, not the other way round
Group plants by the light a position actually offers. Ferns, pothos, snake plants, and ZZ plants manage in the 50–150 µmol/m²/s range, roughly 4–6 mol/m²/day. Philodendrons, most ficus, and peace lilies sit comfortably at 150–300 µmol/m²/s. Herbs, succulents, and citrus want 300–600 or more and will not be satisfied by a north-facing shelf however bright it looks to you. The figures vary by species and by how long a plant has adapted, so use them to sort positions rather than to grade your plants.
Moving the plant is almost always cheaper than moving the furniture. A stool that lifts a fern 30 cm closer to a window can double its light; a sheer curtain turns a scorching south window into a usable one for ferns and calatheas. Rotate pots a quarter turn each week so the side facing the glass does not become the only side with leaves, and in winter shift the whole collection toward the brightest glass you have.
Signs you overshot
Bleaching shows as pale, almost painted patches on leaves that were previously green, usually on the side facing the light. Crisp brown edges on new growth, leaves cupping downward or curling away from the source, washed-out colour on a plant that used to be deep green, and a soil surface that dries within hours of watering all point the same way. Raise the panel 10–15 cm or cut the photoperiod by two hours, then give the plant a fortnight to respond before changing anything else.
Do not confuse light damage with underwatering. Lift the pot: a light, dry pot means water, while a heavy pot with bleached leaves means the light is the problem. Too little light looks different again — long gaps between leaves, small new leaves, variegation fading to plain green, and a plant that has not moved in months. Those are the ones to move closer to the glass or under a panel, not the ones to feed harder.