A pothos can push a root through the drainage hole and still have plenty of room inside the pot. A fern can show nothing at the hole and be a solid mat of roots from top to bottom. The only dependable test begins when the plant comes out of the container, and most repotting advice gets that order backwards.
Roots out of the drainage hole is not proof
Roots leave through the hole because they grow toward moisture and darkness, not because the pot is full. One adventurous root is a reason to look, not a verdict. The more reliable signals are elsewhere: water that runs straight through the pot, mix that dries within a day or two in ordinary weather, roots circling the surface, soil pushed up above the rim, and a plant that tips because the top has outgrown the base.
Slide the plant out to check. Water it the day before so the mix holds together, press the sides of the pot to loosen the root ball, then invert the pot with the stems between your fingers and lift it away. A ball with white tips and visible mix between the roots can wait another season; a dense brown mat with little mix showing is ready. Look at the roots near the surface and the base, not only the ones at the hole.
The 1-2 inch rule and its exceptions
Move up about 2.5–5 cm (1–2 in) in pot diameter, not more. From 15 cm to 18 cm is roughly 44% more surface area at the same depth, and from 15 cm to 20 cm is roughly 78% — already a large jump for a root ball that was only moderately crowded. The point of a modest increase is that new roots reach the fresh mix quickly and the extra volume dries at roughly the same rate as the old ball.
| Current pot | Next size | Typical use |
|---|---|---|
| 10 cm (4 in) | 12.5 cm (5 in) | seedlings, small ferns |
| 15 cm (6 in) | 18 cm (7 in) | most houseplants |
| 20 cm (8 in) | 25 cm (10 in) | fast-growing aroids |
| 30 cm (12 in) | 35 cm (14 in) | floor plants; check stability |
Exceptions matter. A badly root-bound fast grower in midsummer can take a two-size jump and use it. A plant with rot goes back into the same pot, or a smaller one, after the dead roots come off. Snake plants, succulents, and African violets often flower better when slightly snug, so pot them on only when the root ball is genuinely packed. A top-heavy floor plant may need the same diameter in a heavier material rather than a wider pot.
Preparing the root ball
Loosen the outer roots with your fingers, working around the sides and base, and tease out any that have started to circle. Straighten what you can and trim with clean shears what you cannot, removing at most a third of the root mass in one go. Cut away roots that are brown, mushy, or smell sour; healthy roots are firm and pale, though some plants have naturally dark roots, in which case the smell is the better test.
If the ball is a solid mat, score the sides in three or four places, 1–2 cm deep, and slice a thin layer off the base. This sounds brutal and is usually kinder than leaving a tight spiral that keeps growing in its old direction. Do not wash all the old mix away unless you are treating rot or inspecting for pests; the fine roots lost in that process cost the plant more than the fresh mix gains.
Soil choice by plant type
Match the mix to how the plant drinks and how you water. A chunky aroid mix of roughly five parts bark, three parts perlite, and two parts coco coir drains fast and suits monsteras, philodendrons, and pothos. Ferns, calatheas, and other moisture-lovers prefer something that holds water: about four parts coir or peat, three parts compost, two parts perlite, and one part fine bark. Succulents and cacti want half or more of the volume in mineral material such as pumice or perlite.
| Plant group | Mix | Watering implication |
|---|---|---|
| Aroids | 5 bark : 3 perlite : 2 coir | water once the surface feels dry |
| Ferns, calatheas | 4 coir : 3 compost : 2 perlite : 1 bark | keep lightly moist, never soggy |
| Succulents | 1 organic : 1 pumice | soak, then dry out fully |
Pre-moisten the mix before potting so it does not repel water, and use a pot with drainage holes; a decorative outer pot is fine as long as you empty it. If you water weekly, a chunky mix in a warm room may dry too fast; if you water every two weeks, a moisture-retentive mix in a cool room may stay wet too long. The mix and your routine have to agree.
The first two weeks after potting
Water until it drains freely, then set the pot where excess can run off, and put it back in bright indirect light — no harsh afternoon sun for 7–14 days. Skip fertiliser for 2–4 weeks, longer if the mix already contains slow-release granules, because damaged roots and concentrated salts are a poor combination. Expect some wilt for 3–7 days; that is transplant response, not a reason to water again.
Check moisture after five days by lifting the pot or feeling the mix, not by the calendar. Keep the plant out of drafts and away from radiators, and resist moving it around while it settles. If the top is heavy, tie it to a stake loosely for a few weeks. New growth is the signal that the roots have taken hold, and in winter it may not appear for a month.
Mistakes that show up a month later
Overpotting is the slow one. A root ball that occupies a small fraction of a large pot sits in wet mix, dries unevenly, and can sour in the centre; yellowing lower leaves, leaf drop, and a sour smell three to six weeks later are the usual result. Burying the crown — the point where stems meet roots — is another delayed failure, because the buried stem stays wet and rots. So is potting into a cachepot with no drainage, or leaving a saucer full.
Feeding at potting time, or using a mix already charged with fertiliser and adding more, can burn new roots and show up as crisp leaf margins. A plant that sulks for two to six weeks is normal, and ferns and calatheas can take a full season to settle; do not dig it up to check. Wait for new growth before judging the repot, and if a plant is still declining after a month in wet soil with soft stems, unpot it and look at the roots again.